350-401 Practice Test

350-401 Practice Test practice questions, page 37 of 43, with answer review and explanations.

Question 181

Refer to the exhibit. The trunk between Gig1/0/1 of switch SW2 and Gig1/0/1 of switch SW1 is not operational. Which action resolves this issue?

  1. Configure both interfaces to nonegotiate and ensure that the switches are in different VTP domains.
  2. Configure both interfaces in dynamic auto DTP mode and ensure that the switches are in the same VTP domain.
  3. Configure both interfaces in dynamic auto DTP mode and ensure that the switches are in different VTP domains.
  4. Configure both interfaces in dynamic desirable DTP mode and ensure that the switches are in the same VTP domain.

Question 182

Refer to the exhibit. Which two facts does the device output confirm? (Choose two.)

  1. The device's HSRP group uses the virtual IP address 10.0.3.242.
  2. The device is configured with the default HSRP priority.
  3. The device sends unicast messages to its peers.
  4. The standby device is configured with the default HSRP priority.
  5. The device is using the default HSRP hello timer.

Question 183

Refer to the exhibit. Which type of antenna is shown on the radiation patterns?

  1. patch
  2. dipole
  3. omnidirectional
  4. Yagi

Question 184

Drag and drop the descriptions from the left onto the routing protocol they describe on the right. Select and Place:

Question 185

Refer to the exhibit. All switches are configured with the default port priority value. Which two commands ensure that traffic from PC1 is forwarded over the Gi1/3 trunk port between DSW1 and DSW2? (Choose two.)

  1. DSW2(config)#interface gi1/3
  2. DSW1(config-if)#spanning-tree port-priority 0
  3. DSW2(config-if)#spanning-tree port-priority 128
  4. DSW1(config)#interface gi1/3
  5. DSW2(config-if)#spanning-tree port-priority 16