350-401 Practice Test

350-401 Practice Test practice questions, page 36 of 43, with answer review and explanations.

Question 176

How does the EIGRP metric differ from the OSPF metric?

  1. The EIGRP metric is calculated based on bandwidth only. The OSPF metric is calculated on delay only.
  2. The EIGRP metric is calculated based on delay only. The OSPF metric is calculated on bandwidth and delay.
  3. The EIGRP metric is calculated based on bandwidth and delay. The OSPF metric is calculated on bandwidth only.
  4. The EIGRP metric is calculated based on hop count and bandwidth. The OSPF metric is calculated on bandwidth and delay.

Question 177

Refer to the exhibit. An engineer is installing a new pair of routers in a redundant configuration. Which protocol ensures that traffic is not disrupted in the event of a hardware failure?

  1. HSRPv1
  2. GLBP
  3. VRRP
  4. HSRPv2

Question 178

Refer to the exhibit. After an engineer configures an EtherChannel between switch SW1 and switch SW2, this error message is logged on switch SW2: SW2# 09:45:32: %PM-4-ERR_DISABLE: channel-misconfig error detected on Gi0/0, putting Gi0/0 in err-disable state 09:45:32: %PM-4-ERR_DISABLE: channel-misconfig error detected on Gi0/1, putting Gi0/1 in err-disable state Based on the output from switch SW1 and the log message received on switch SW2, what action should the engineer take to resolve this issue?

  1. Configure the same protocol on the EtherChannel on switch SW1 and SW2.
  2. Define the correct port members on the EtherChannel on switch SW1.
  3. Correct the configuration error on Interface Gi0/0 on switch SW1.
  4. Correct the configuration error on Interface Gi0/1 on switch SW1.

Question 179

Refer to the exhibit. Communication between London and New York is down. Which command set must be applied to resolve this issue?

  1. NewYork(config)#int f0/1 NewYork(config)#switchport nonegotiate NewYork(config)#end NewYork#
  2. NewYork(config)#int f0/1 NewYork(config)#switchport mode trunk NewYork(config)#end NewYork#
  3. NewYork(config)#int f0/1 NewYork(config)#switchport trunk encap dot1q NewYork(config)#end NewYork#
  4. NewYork(config)#int f0/1 NewYork(config)#switchport mode dynamic desirable NewYork(config)#end NewYork#

Question 180

Which encryption hashing algorithm does NTP use for authentication?

  1. SSL
  2. MD5
  3. AES128
  4. AES256