350-401 Practice Test

350-401 Practice Test practice questions, page 38 of 43, with answer review and explanations.

Question 186

A company has an existing Cisco 5520 HA cluster using SSO. An engineer deploys a new single Cisco Catalyst 9800 WLC to test new features. The engineer successfully configures a mobility tunnel between the 5520 cluster and 9800 WLC. Clients connected to the corporate WLAN roam seamlessly between access points on the 5520 and 9800 WLC. After a failure on the primary 5520 WLC, all WLAN services remain functional; however, clients cannot roam between the 5520 and 9800 controllers without dropping their connection. Which feature must be configured to remedy the issue?

  1. mobility MAC on the 5520 cluster
  2. mobility MAC on the 9800 WLC
  3. new mobility on the 5520 cluster
  4. new mobility on the 9800 WLC

Question 187

Refer to the exhibit. Which configuration change ensures that R1 is the active gateway whenever it is in a functional state for the 172.30.110.0/24 network?

  1. R2 standby 1 priority 90 standby 1 preempt
  2. R2 standby 1 priority 100 standby 1 preempt
  3. R1 standby 1 preempt R2 standby 1 priority 90
  4. R1 standby 1 preempt R2 standby 1 priority 100

Question 188

A customer has completed the installation of a Wi-Fi 6 greenfield deployment at their new campus. They want to leverage Wi-Fi 6 enhanced speeds on the trusted employee WLAN. To configure the employee WLAN, which two Layer 2 security policies should be used? (Choose two.)

  1. WPA2 (AES)
  2. 802.1X
  3. OPEN
  4. WEP
  5. WPA (AES)

Question 189

Which two actions, when applied in the LAN network segment, will facilitate Layer 3 CAPWAP discovery for lightweight AP? (Choose two.)

  1. Utilize DHCP option 43.
  2. Utilize DHCP option 17.
  3. Configure an ip helper-address on the router interface.
  4. Enable port security on the switch port.
  5. Configure WLC IP address on LAN switch

Question 190

Refer to the exhibit. Which action resolves the EtherChannel issue between SW2 and SW3?

  1. Configure switchport mode trunk on SW2.
  2. Configure switchport nonegotiate on SW3.
  3. Configure channel-group 1 mode desirable on both interfaces.
  4. Configure channel-group 1 mode active on both interfaces.