HPE7-A08 Practice Test

HPE7-A08 Practice Test practice questions, page 7 of 7, with answer review and explanations.

Question 31

An Aruba CX8100 VSX has the following state for LACP: What can be observed based on the output?

  1. The local lag253 configuration is set as a custom
  2. The peer lag253 needs to have a valid AGGR key
  3. The local lag253 configuration is set as default
  4. The local lag27 would need to have individual AGGR key

Question 32

Refer to the exhibit: The current startup configuration on the HPE Aruba Networking CX 6300 switch no longer includes a device profile that was created on the previous day. Based on the exhibit, how can you validate if the configuration was removed without changing the current configuration?

  1. Use show checkpoint to see the changes created between the available checkpoints.
  2. Use checkpoint diff to check for differences between the startup-config and available checkpoints.
  3. Use copy startup-config checkpoint <checkpoint-name> to see the changes created between the available checkpoints.
  4. Use checkpoint rollback to see the changes created between the available checkpoints.

Question 33

You have applied the following OSPF configuration but are not seeing any output from the command below. What is the reason for this?

  1. A loopback interface hasn’t been configured on Agg-2.
  2. A VRF wasn’t specified in the show command.
  3. OSPF interfaces are passive by default.
  4. A different OSPF process ID is used on each switch.