HPE7-A08 Practice Test

HPE7-A08 Practice Test practice questions, page 6 of 7, with answer review and explanations.

Question 26

Refer to the exhibit: The neighbor switch is configured with the following IP interfaces: mgmt.: 172.30.32.8 loopback 0: 10.255.255.2 vlan 5: 192.168.5.2 How can you change the advertised management IP information to appear as the VLAN 5 IP?

  1. Under interface vlan 5, issue command: lldp management-address
  2. Issue in global context command: lldp management-address vlan 5
  3. Under lldp context: lldp management-address 192.168.5.2
  4. Issue in global context command: lldp management-ipv4-address vlan 5

Question 27

You need to configure BGP on an HPE Aruba Networking switch using AS 65010. What is required when establishing peering with neighboring devices using eBGP AS 65100?

  1. Use of peer AS65001
  2. Use of route-reflector
  3. Use of directory connected peer
  4. Use of address-family ipv4 internal

Question 28

Refer to the exhibit. Interfaces 1/1/53 and 1/1/54 were accidentally disconnected from Switch-A, the primary VSX member. Client A is experiencing network disruptions with network connections to Router-A. What needs to be done to prevent user traffic disruption in this scenario?

  1. Configure VSX shutdown on-split on SW-B.
  2. Configure keepalive VLAN on upstream lag.
  3. Configure VSX shutdown on-split on SW-A.
  4. Configure keepalive using mgmt ports between SW-A and SW-B.

Question 29

An HPE Aruba Networking CX switch is managed in HPE Aruba Networking Central. If you need to validate configuration changes in the switch’s Global view, what information can you get using the Audit trail?

  1. The configuration changes history is up to 7 years.
  2. The configuration difference that was pushed to the device.
  3. The method used to create the configuration (template, multi-edit, or GUI).
  4. The username of the person who pushed the configuration.

Question 30

You have applied the following OSPG configuration but are seeing the output from the command below. What is the reason for this?

  1. OSPF interfaces are passive by default.
  2. A Layer-3 interface has not been associated with a VRF.
  3. A different OSPF process ID is used on each switch.
  4. A loopback interface hasn’t been configured on Agg-2.