HPE7-A08 Practice Test

HPE7-A08 Practice Test practice questions, page 4 of 7, with answer review and explanations.

Question 16

Your customer’s CISO would like to deploy colorless ports across the network. Which will you need to configure to meet this requirement?

  1. 802.1Q
  2. 802.1X
  3. 802.11X
  4. 802.1AD

Question 17

Refer to the exhibit for an HPE Aruba Networking CX 6300M VSF: If Member ID 1 fails, what would be the state of Member ID 2?

  1. Conductor
  2. Standby
  3. Not present
  4. Member

Question 18

Refer to the exhibit. SW-A is the layer-3 gateway for: -Server-A in VLAN 100, subnet 10.100.100.0/24 -Client-A in VLAN 20, subnet 10.100.20.0/24 -Client-B VLAN 30, subnet 10.100.30.0/24 What can be done to trust DHCP server 10.100.100.10 responses on SW-A for clients in VLAN 20?

  1. Enable dhcpv4-snooping authorized-server 10.100.100.10 on VLAN 100
  2. Enable dhcpv4-snooping and authorized-server 10.100.100.10 globally
  3. Enable dhcpv4-snooping authorized-server 10.100.100.10 on VLAN 20
  4. Enable dhcpv4-snooping trust 10.100.100.10 on VLAN 100

Question 19

You are remotely connected to an HPE Aruba Networking CX 6200M switch using SSH to change the Control Plane ACL, allowing only defined subnets to access the switch with the assistance of the checkpoint auto 10 command. Later in the day, you are testing if the control-plane ACL is working, and you notice that access is allowed from all networks. What needs to be done with the checkpoint feature to have the remaining without rolling back?

  1. Use the checkpoint commit command before you commit the change.
  2. Use the checkpoint commit after you commit the change.
  3. Use the checkpoint auto command after you commit the change.
  4. Use the checkpoint auto command before you commit the change.

Question 20

Refer to the exhibit: A senior network architect has created the configuration above. You are implementing the set up in building A and B. The actual fiber distance between the building locations is: 200m /656ft utilizing OM3 cabling. What needs to be changed on the configuration based on the actual environmental conditions to support always-on Poe in the Building B 5th floor?

  1. Replace the CX6100 switch with CX6200
  2. Replace the CX6100 switch with CX8320
  3. Replace the CX6100 switch with CX4100i
  4. Replace the CX6100 switch with CX8100