HPE7-A06 Practice Test

HPE7-A06 Practice Test practice questions, page 4 of 5, with answer review and explanations.

Question 16

What is the most secure way to configure HPE Aruba Networking access points for employee/guest access?

  1. Configure VLANs to segregate employee and guest traffic but use the same default password for all VLANs.
  2. Use WPA2 Enterprise encryption with a RADIUS server but use a weak pre-shared key (PSK) for the RADIUS server.
  3. Use a single SSID for employee and guest access and configure a captive portal for guest access.
  4. Use separate SSIDs for employee and guest access and configure an HPE Aruba Networking ClearPass Policy Manager for guest authentication.

Question 17

A customer deployment with 40 locations and an average of 500 access points per location is being deployed in HPE Aruba Networking Central. Gateways are used to tunnel the traffic for each location and should be detected and built automatically. What is the correct approach for the cluster setup?

  1. Manual: Auto Config
  2. Manual: Auto Cluster
  3. Automatic: Auto Group
  4. Automatic: Auto Site

Question 18

An OSPF router has learned a path to an external network by both an E1 and E2 advertisement, both routes having the same path cost. Which path will the router prefer?

  1. Both routes will be suppressed until the path conflict has been resolved.
  2. The router will use both paths equally my means of ECMP.
  3. The router will prefer the E1 path.
  4. The router will prefer the E2 path.

Question 19

A client would like to use the HPE Aruba Networking Switch MultiEdit Software function in HPE Aruba Networking Central. Which option is available?

  1. Use CLI scripts and apply them to selected switches.
  2. Run the same NAE scripts for selected switches.
  3. Use templates and apply them to selected switches.
  4. Apply a configuration to an interface range for selected switches.

Question 20

You are configuring an SSID that is using 802.1X as a security mechanism. What is the reason for using WPA3-Enterprise (CCM-128) when deploying Wi-Fi 6 networks?

  1. WPA3-Enterprise (CCM-128) is also called WPA3-Enterprise Transition Mode. It will allow WPA2 clients to connect.
  2. WPA3-Enterprise (CCM-128) is also called WPA3-Enterprise Compatibility Mode. It will allow WPA2 clients to connect.
  3. WPA3-Enterprise (CCM-128) is also called WPA3-Enterprise Only Mode. There is no support for WPA2 clients.
  4. WPA3-Enterprise (CCM-128) is also called WPA3-Enterprise 192-bit mode. It is WPA3 only and enforces specific EAP certificate ciphers.