AX0-100

AX0-100 practice questions, page 4 of 6, with answer review and explanations.

Question 16

A customer has a lot of motion blur on recordings from a fixed camera. What would be the most likely setting to address the blurring?

  1. Gain level
  2. Brightness
  3. Backlight compensation
  4. Shutter speed

Question 17

Which statement is true regarding H.264 and Motion JPEG?

  1. The highest bandwidth savings using H.264 compared to Motion JPEG is at high frame rates
  2. Bandwidth savings using H.264 has nothing to do with frame rate, only scene complexity
  3. Bandwidth savings using H.264 has nothing to do with frame rate, only Group of Video (GOV) setting
  4. The highest bandwidth savings using H.264 compared to Motion JPEG is at low frame rates

Question 18

Which of the following will allow a customer to have a PTZ camera automatically change between three predefined positions?

  1. Configure the camera's I/O ports to control the preset positions
  2. Use the Guard Tour capability to switch between the preset positions
  3. Switch between the predefined positions using a joystick
  4. Use the auto tracking capability to switch between the preset positions

Question 19

In a network surveillance installation, the purpose of a router is to

  1. Forward the video stream between networks.
  2. Forward the video stream to the correct receiver within a network.
  3. Separate audio and video traffic to reduce audio latency.
  4. Separate the video stream from the camera control signaling.

Question 20

Which of the following conditions has to be met to use multicast streaming?

  1. The network infrastructure has to support multicast
  2. The client has to run AXIS Camera Management or AXIS Camera Station
  3. The client has to support streaming over RTSP
  4. The video device needs to run on firmware version 5.20 or higher