350-601 Practice Test

350-601 Practice Test practice questions, page 6 of 21, with answer review and explanations.

Question 26

An engineer must configure a Nexus 7000 series switch for HSRP on VLAN 100. When fully functional, the router must be the active master. Which set of commands must be used to implement the scenario?

  1. feature hsrp interface vlan100 ip address 10.1.1.2 255.255.255.0 priority 255 preempt hsrp version 2 hsrp 1000 ip 10.1.1.1
  2. feature-set hsrp interface vlan100 ip address 10.1.1.2 255.255.255.0 priority 20 preempt hsrp version 2 hsrp 1000 ip 10.1.1.1
  3. feature-set hsrp interface vlan100 ip address 10.1.1.2 255.255.255.0 priority 80 preempt hsrp version 2 hsrp 1000 ip 10.1.1.1
  4. feature hsrp interface vlan100 ip address 10.1.1.2 255.255.255.0 priority 240 preempt hsrp version 2 hsrp 1000 ip 10.1.1.1

Question 27

Which MAC address is an HSRP version 2?

  1. 3842.4250.0000
  2. 0000.0C07.AC1H
  3. 0000.0C9F.F0C8
  4. 0100.5E7F.FFFF

Question 28

Refer to the exhibit. Which VLANs are capable to be assigned on vPC interfaces?

  1. 100-102
  2. 100-103
  3. 100-104
  4. 100-105

Question 29

An engineer need to implement a solution that prevents loops from occurring accidentally by connecting a switch to interface Ethernet1/1. The port is designated to be used for host connectivity. Which configuration should be implemented?

  1. switch# configure terminal switch(config)# interface Ethernet1/1 switch(config-if)# spanning-tree bpduguard enable
  2. switch# configure terminal switch(config)# interface Ethernet1/1 switch(config-if)# spanning-tree guard loop
  3. switch# configure terminal switch(config)# interface Ethernet1/1 switch(config-if)# spanning-tree loopguard default
  4. switch# configure terminal switch(config)# interface Ethernet1/1 switch(config-if)# spanning-tree bpdufilter enable

Question 30

A network engineer repeatedly saves a configuration on Catalyst switches to NVRAM using the write memory command. Which action should be taken to implement the same action on Nexus switches?

  1. Use the alias command to use the write memory command.
  2. Use the wri command to use the copy running-config startup-config command.
  3. Use the exit command to leave the configuration mode and save the configuration automatically.
  4. Use the write memory command to save the configuration.