350-601 Practice Test

350-601 Practice Test practice questions, page 5 of 21, with answer review and explanations.

Question 21

What are two capabilities of the Cisco Network Assurance Engine? (Choose two.)

  1. It validates that devices comply with network security policies.
  2. It predicts the impact of changes to the network.
  3. It predicts the network load on a data center.
  4. It ensures that network performance meets an SLA.
  5. It verifies the speed of network packet flows by using telemetry.

Question 22

What is an advantage of streaming telemetry over SNMP?

  1. on-change traps sent to a receiver
  2. periodic push-based subscription messages
  3. periodic polling of the device status
  4. MD5-based authentication on polling

Question 23

APIC EPG Resolution Immediacy is set to "Immediate". Which statement is true about the Deployment Immediacy for VMM domains associated to EPGs?

  1. If "On demand" is selected, the policy is programmed in the hardware only when the first packet is received through the data path.
  2. If "Immediate" is selected, the policy is programmed in the hardware as soon as the leaf is booted.
  3. The "Immediate" and "On demand" options require a port group to be created on the VDS.
  4. If "On demand" is selected, the policy is programmed in the hardware only when the APIC detects a VM created in the EPG.

Question 24

Refer to the exhibit. All switches are configured with the default OSPF priority. Which configuration should be applied to ensure that the SW2 Cisco Nexus switch controls the LSA floods and advertises the network to the remaining nodes in the OSPFv2 area?

  1. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 255
  2. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 1
  3. SW2# configure terminal SW2 (config)# router ospf 1 SW2 (config-router)# router-id 10.10.10.22
  4. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 0

Question 25

Refer to the exhibit. In a bidirectional PIM network using Phantom RP as an RP redundancy mechanism, two Cisco NX-OS routers have these requirements: ✑ R1 must be the active RP. ✑ R2 must be the backup RP that is used only if R1 is not reachable. Drag and drop the configuration steps to complete the configuration for Router 2. Not all configuration steps are used. Select and Place: