350-601 Practice Test

350-601 Practice Test practice questions, page 13 of 21, with answer review and explanations.

Question 61

Refer to the exhibit. An engineer needs to implement streaming telemetry on a Cisco MDS 9000 Series Switch. The requirement is for the show command data to be collected every 30 seconds and sent to receivers. Which command must be added to the configuration to meet this requirement?

  1. snsr-grp 200 sample-interval 30000
  2. snsr-grp 200 sample-interval 30
  3. sensor-grp 200 sample-period 30
  4. sensor-grp 200 sample-period 30000

Question 62

An engineer must configure OSPF in the data center. The external routes have already been redistributed into OSPF. The network must meet these criteria: * The data center servers must reach services in the cloud and the services behind the redistributed routes. * The exit point toward the Internet should be propagated only when there is a dynamically learned default route from the upstream router. Which feature is required?

  1. stubby area
  2. totally stubby area
  3. default-information originate
  4. default-information originate always

Question 63

An engineer must configure a VXLAN routing on a Cisco Nexus 9000 Series Switch. The engineer requires a solution where all the leaf switches have the same gateway MAC and IP addresses. Which configuration set accomplishes this task?

  1. NX9K(config)# fabric forwarding anycast-gateway-mac AA:BB:AA:BB:AA:BB NX9K(config)# interface VLAN-interface-name NX9K(config-if)# vrf member vrf-name NX9K(config-if)# fabric forwarding mode anycast-gateway
  2. NX9K(config)# install feature-set fabric NX9K(config)# feature-set fabric NX9K(config)# fabric forwarding anycast-gateway-mac AA:BB:AA:BB:AA:BB NX9K(config)# interface VLAN-interface-name NX9K(config-if)# fabric forwarding mode anycast-gateway
  3. NX9K(config)# install feature-set fabric NX9K(config)# feature-set fabric NX9K(config)# fabric forwarding anycast-gateway-mac AA:BB:AA:BB:AA:BB NX9K(config)# interface VLAN-interface-name NX9K(config-if)# vrf member vrf-name NX9K(config-if)# fabric forwarding mode anycast-gateway
  4. NX9K(config)# fabric forwarding anycast-gateway-mac AA:BB:AA:BB:AA:BB NX9K(config)# interface VLAN-interface-name NX9K(config-if)# fabric forwarding mode anycast-gateway

Question 64

An engineer implements an ACI fabric and must implement microsegmentation of endpoints within the same IP subnet using a network-based attribute. The attribute mapping must allow IP subnet independence. Which attribute must be selected?

  1. IP
  2. tag
  3. custom
  4. MAC address

Question 65

What is a characteristic of the install all command on the Cisco Nexus Series Switch?

  1. automatically checks the image integrity
  2. continues the upgrade process if any step in the sequence fails
  3. upgrades only certain modules
  4. impacts data plane traffic