350-601 Practice Test practice questions, page 12 of 21, with answer review and explanations.
Question 56
An environment consists of a Cisco MDS 9000 Series Switch that uses port channels. An engineer must ensure that frames between the source and the destination follow the same links for a specific flow. Subsequent flows are allowed to use a different link. Which load balancing method should be used to accomplish this goal?
src-id/dst-id
src-dst-oui
src-dst-port
src-id/dst-id/oxid
Question 57
Refer to the exhibit. An engineer must monitor ingress traffic from SW1 and SW2 port-channel interfaces from SW3. Which configuration must be implemented to accomplish this goal?
Question 58
Refer to the exhibit. A host with a source address 10.10.10.10 sends traffic to multicast group 239.1.1.1. How do the vPC switches forward the multicast traffic?
If multicast traffic is received on Switch1 over the vPC peer-link, the traffic is dropped
If multicast traffic is received on Po10 Switch1, the traffic is forwarded out on Po1 and Po20
If multicast traffic is received on Po11 Switch2, the traffic is forwarded out only on Po20
If multicast traffic is received on Po11 Switch2, the traffic is dropped.
Question 59
A network architect must redesign a data center network based on OSPFv2. The network must perform fast reconvergence between directly connected switches. Which two actions must be taken to meet the requirements? (Choose two.)
Set low OSPF hello and DEAD timers.
Configure all links on AREA 0.
Enable BFD for failure detection.
Use OSPF point-to-point links only.
Implement a virtual link between the switches.
Question 60
Refer to the exhibit. Which configuration ensures that the Cisco Nexus 7000 Series Switches are the primary devices for LACP?
N7K_A(config-vpc-domain)# role priority 1 N7K_B(config-vpc-domain )# role priority 2