300-430 Practice Test

300-430 Practice Test practice questions, page 3 of 13, with answer review and explanations.

Question 11

An organization is supporting remote workers in different locations. In order to provide wireless network connectivity and services, OfficeExtend has been implemented. The wireless connectivity is working, but users report losing connectivity to their local network printers. Which solution must be used to address this issue?

  1. OEAP gateway override
  2. OEAP split tunnel
  3. WLAN static IP tunneling
  4. FlexConnect local switching

Question 12

What is configured to use more than one port on the OEAP to extend the wired network?

  1. remote LAN ACL
  2. AAA override
  3. client load balancing
  4. remote LAN

Question 13

An engineer must implement Cisco Identity-Based Networking Services at a remote site using ISE to dynamically assign groups of users to specific IP subnets. If the subnet assigned to a client is available at the remote site, then traffic must be offloaded locally, and subnets are unavailable at the remote site must be tunneled back to the WLC. Which feature meets these requirements?

  1. learn client IP address
  2. FlexConnect local authentication
  3. VLAN-based central switching
  4. central DHCP processing

Question 14

An engineer must configure Cisco OEAPs for three executives. As soon as the NAT address is configured on the management interface, it is noticed that the WLC is not responding for APs that are trying to associate to the internal IP management address. Which command should be used to reconcile this?

  1. config flexconnect office-extend nat-ip-only disable
  2. config network ap-discovery nap-ip-only enable
  3. config flexconnect office-extend nat-ip-only enable
  4. config network ap-discovery nat-ip-only disable

Question 15

An engineer is responsible for a wireless network for an enterprise. The enterprise has distributed offices around the globe, and all APs are configured in FlexConnect mode. The network must be configured to support 802.11r and CCKM. What needs to be implemented to accomplish this goal?

  1. Enable VLAN-based central switching.
  2. Enable FlexConnect local authentication.
  3. Enable FlexConnect local switching.
  4. Create FlexConnect groups.