300-410 Practice Test

Question 106

Drag and drop the operations from the left onto the locations where the operations are performed on the right. Select and Place:

Question 107

Which protocol does MPLS use to support traffic engineering?

1. TDP
2. RSVP
3. LDP
4. BGP

Question 108

An engineer configured a company's multiple area OSPF Head Office router and Site A Cisco routers with VRF lite. Each site router is connected to a PE router of an MPLS backbone: Head Office & Site A - ip cef ip vrf abc rd 101:101 ! interface FastEthernet0/0 ip vrf forwarding abc ip address 172.16.16.X 255.255.255.252 ! router ospf 1 vrf abc log-adjacency-changes network 172.16.16.0 0.0.0.255 area 1 After finishing both site router configurations, none of the LSA 3, 4, 5, and 7 are installed at Site A router. Which configuration resolves this issue?

1. configure capability vrf-lite on Site A and its connected PE router under router ospf 1 vrf abc
2. configure capability vrf-lite on both PE routers connected to Head Office and Site A routers under router ospf 1 vrf abc
3. configure capability vrf-lite on Head Office and its connected PE router under router ospf 1 abc
4. configure capability vrf-lite on Head Office and Site A routers under router ospf 1 vrf abc

Question 109

Refer to the exhibit. The Los Angeles and New York routers are receiving routers from Chicago but not from each other. Which configuration fixes the issue?

1. interface Tunnel1 no ip split-horizon eigrp 111
2. interface Tunnel1 ip next-hop-self eigrp 111
3. interface Tunnel1 tunnel mode ipsec ipv4
4. interface Tunnel1 tunnel protection ipsec profile IPSec-PROFILE

Question 110

Drag and drop the MPLS VPN device types from the left onto the definitions on the right. Select and Place: