200-301 Practice Test

200-301 Practice Test practice questions, page 27 of 56, with answer review and explanations.

Question 131

Drag and drop the IPv6 address type characteristics from the left to the right. Select and Place:

Question 132

Refer to the exhibit. The IP address configurations must be completed on the DC-1 and HQ-1 routers based on these requirements: ✑ DC-1 Gi1/0 must be the last usable address on a /30 ✑ DC-1 Gi1/1 must be the first usable address on a /29 ✑ DC-1 Gi1/2 must be the last usable address on a /28 ✑ HQ-1 Gi1/3 must be the last usable address on a /29 Drag and drop the commands from the left onto the destination interfaces on the right. Not all commands are used. Select and Place:

Question 133

How is RFC 1918 addressing used in a network?

  1. They are used to access the Internet from the internal network without conversion.
  2. They are used in place of public addresses for Increased security.
  3. They are used with NAT to preserve public IPv4 addresses.
  4. They are used by Internet Service Providers to route over the Internet.

Question 134

Drag and drop the IPv6 address types from the left onto their descriptions on the right. Select and Place:

Question 135

Refer to the exhibit. What is a reason for poor performance on the network interface?

  1. The interface is receiving excessive broadcast traffic.
  2. The bandwidth setting of the interface is misconfigured.
  3. The cable connection between the two devices is faulty.
  4. The interface is operating at a different speed than the connected device.