VCS-279

VCS-279 practice questions, page 3 of 4, with answer review and explanations.

Question 11

An administrator wants deduplication clients in a remote office to perform backups so less data is sent over the wide area network (WAN). Which action should the administrator perform to reduce the total amount of data sent over the WAN?

  1. set client attributes to “Always use the media server”
  2. set client attributes to “Always use client-side deduplication”
  3. set the deduplication disk pool to “Limit I/O streams”
  4. enable deduplication stream handlers for the clients

Question 12

Which type of punctuation is used to separate multiple interface name entries in the Network > Show Properties [InterfaceNames] command in the NetBackup Appliance Shell Menu (CLISH)?

  1. colon
  2. comma
  3. space
  4. semicolon

Question 13

A file system on a server that has different files changing daily becomes corrupt, and a restore is required. The system is being backed up using True Image Restore with move detection enabled. The most recent backups of this file system are displayed below: Monday: A full backup - Tuesday: A differential incremental backup Wednesday: A cumulative incremental backup Thursday: A differential incremental backup Friday: A differential incremental backup What is the minimum number of backup images that will be used to fully restore the server to its most current state?

  1. one
  2. two
  3. three
  4. four
  5. five

Question 14

Which command should an administrator run to display all images written to both disk and tape for a particular client?

  1. bplist
  2. bpimmedia
  3. bpmedia
  4. bpclntcmd

Question 15

Which steps should an administrator perform to run an upgrade pre-check for multiple Windows and Linux clients using VxUpdate, without performing the upgrade?

  1. run a pre-check for each client manually using the nbinstallcmd command
  2. configure the pre-check to run for all clients concurrently in Deployment Policies > Schedules
  3. run a pre-check for each client manually using the nbrepo command
  4. configure the pre-check to run for all clients concurrently in Deployment Policies > Attributes