NSE8_812 Practice Test

NSE8_812 Practice Test practice questions, page 3 of 5, with answer review and explanations.

Question 11

Refer to the exhibit. You are operation an internal network with multiple OSPF routers on the same LAN segment. FGT_3 needs to be added to the OSPF network and has the configuration shown in the exhibit. FGT_3 is not establishing any OSPF connection. What needs to be changed to the configuration to make sure FGT_3 will establish OSPF neighbors without affecting the DR/BDR election?

Question 12

A retail customer with a FortiADC HA cluster load balancing five webservers in L7 Full NAT mode is receiving reports of users not able to access their website during a sale event. But for clients that were able to connect, the website works fine. CPU usage on the FortiADC and the web servers is low, application and database servers are still able to handle more traffic, and the bandwidth utilization is under 30%. Which two options can resolve this situation? (Choose two.)

  1. Change the persistence rule to LB_PERSIS_SSL_SESS_ID
  2. Add more web servers to the real server pool
  3. Disable SSL between the FortiADC and the web servers
  4. Add a connection-pool to the FortiADC virtual server

Question 13

Refer to the CLI output: Given the information shown in the output, which two statements are correct? (Choose two.)

  1. Geographical IP policies are enabled and evaluated after local techniques
  2. Attackers can be blocked before they target the servers behind the FortiWeb
  3. The IP Reputation feature has been manually updated
  4. An IP address that was previously used by an attacker will always be blocked
  5. Reputation from blacklisted IP addresses from DHCP or PPPoE pools can be restored

Question 14

Refer to the exhibit. You are deploying a FortiGate 6000F. The device should be directly connected to a switch. In the future, a new hardware module providing higher speed will be installed in the switch, and the connection to the FortiGate must be moved to this higher-speed port. You must ensure that the initial FortiGate interface connected to the switch does not affect any other port when the new module is installed and the new port speed is defined. How should the initial connection be made?

  1. Connect the switch on any interface between ports 21 to 24
  2. Connect the switch on any interface between ports 25 to 28
  3. Connect the switch on any interface between ports 1 to 4
  4. Connect the switch on any interface between ports 5 to 8

Question 15

You are designing a setup where the FortiGate device is connected to two upstream ISPs using BGP. Part of the requirement is that you must be able to refresh the route advertisements manually without disconnecting the BGP neighborships. Which feature must you enable on the BGP neighbors to accomplish this goal?

  1. Graceful-restart
  2. Deterministic-med
  3. Synchronization
  4. Soft-reconfiguration