NSE7_SDW-7.0 practice questions, page 3 of 3, with answer review and explanations.
Question 11
Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)
The sdwan_service_id flag in the session information is 0.
All SD-WAN rules have the default setting enabled.
Traffic does not match any of the entries in the policy route table.
Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
Question 12
Refer to the exhibit. An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0. Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)
The traffic matches a regular policy route configured with T_INET_1_0 as the outgoing device.
T_INET_1_0 has a lower route priority value (higher priority) than T_INET_0_0.
T_INET_0_0 does not have a valid route to the destination.
T_INET_1_0 has a higher member configuration priority than T_INET_0_0.