NSE6_SDW_AD-7.6

NSE6_SDW_AD-7.6 practice questions, page 3 of 3, with answer review and explanations.

Question 11

Refer to the exhibits.The SD-WAN zone configuration of an SD-WAN template prepared on FortiManager and the policy package configuration are shown.When you try to install the configuration changes, FortiManager displays an error message.How can you fix the issue?

  1. Configure a normalized interface for the IPsec tunnel HUB1-VPN1.
  2. Configure both HUB1-VPN1 and HUB1-VPN2 as the destination of policy 3.
  3. Configure HUB1 as the destination of policy 3.
  4. Configure branch1_fgt as the installation target for policy 3.

Question 12

FortiManager SD-WAN overlay orchestrator helps prepare SD-WAN deployments. To complete the tasks performed by the SD-WAN overlay orchestrator, you must perform some post-run tasks.Which two mandatory post-run tasks must you perform? (Choose two.)

  1. Create policy packages and assign them to the branch devices.
  2. Configure routing through the overlay tunnels created by the SD-WAN overlay template.
  3. Assign a hub_id metadata variable to each hub device.
  4. Assign an sdwan_id metadata variable to each device (branch and hub).
  5. Configure SD-WAN rules.