NS0-521

NS0-521 practice questions, page 2 of 5, with answer review and explanations.

Question 6

An engineer is troubleshooting FC connectivity issues on a customer’s system and sees the following output from the network fcp adapter show command: According to the output, what is the domain ID of the switch that is connected to port 2a of node n2?

  1. ID 20
  2. ID 1
  3. ID 2
  4. ID 10

Question 7

An SVM is created for FCP traffic. LUNs must be created to share with ESXi hosts for datastores. Which two items must be configured after the LUN is created, for this to happen? (Choose two.)

  1. Create an igroup with the ESXi hosts’ WWPNs.
  2. Create an igroup with the ESXi hosts’ WWNNs.
  3. Map the LUNs to the igroup.
  4. Configure CHAP authentication.

Question 8

A customer is setting up a two-node cluster to serve iSCSI LUNs. How many interfaces should be created?

  1. Two iSCSI LIFs per node
  2. One iSCSI LIF per node
  3. Two iSCSI LIFs per SVM
  4. One iSCSI LIF per SVM

Question 9

An administrator is troubleshooting a SAN network issue where the NVMe/TCP LIF keeps disconnecting. Which command helps the administrator to investigate this issue?

  1. ipspace show
  2. vserver nvme subsystem show
  3. cluster ping-cluster
  4. network port reachability show

Question 10

A customer is using a new two-node NetApp All SAN Array (ASA) configuration with SnapMirror active sync. To verify if everything is set up correctly, the customer is looking at the number of paths in their ESXi hosts. How many paths should the customer see?

  1. 4 Active/Optimized, 4 Active/Unoptimized
  2. 6 Active/Optimized, 2 Active/Unoptimized
  3. 2 Active/Optimized, 6 Active/Unoptimized
  4. 8 Active/Optimized, 0 Active/Unoptimized