N10-008

N10-008 practice questions, page 2 of 35, with answer review and explanations.

Question 6

SIMULATION - You have been tasked with setting up a wireless network in an office. The network will consist of 3 Access Points and a single switch. The network must meet the following parameters: ✑ The SSIDs need to be configured as CorpNet with a key of S3cr3t! ✑ The wireless signals should not interfere with each other ✑ The subnet the Access Points and switch are on should only support 30 devices maximum ✑ The Access Points should be configured to only support TKIP clients at a maximum speed INSTRUCTONS - Click on the wireless devices and review their information and adjust the settings of the access points to meet the given requirements. If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.

Question 7

A network is experiencing a number of CRC errors during normal network communication. At which of the following layers of the OSI model will the administrator MOST likely start to troubleshoot?

  1. Layer 1
  2. Layer 2
  3. Layer 3
  4. Layer 4
  5. Layer 5
  6. Layer 6
  7. Layer 7

Question 8

A client recently added 100 users who are using VMs. All users have since reported slow or unresponsive desktops. Reports show minimal network congestion, zero packet loss, and acceptable packet delay. Which of the following metrics will MOST accurately show the underlying performance issues? (Choose two.)

  1. CPU usage
  2. Memory
  3. Temperature
  4. Bandwidth
  5. Latency
  6. Jitter

Question 9

Client devices cannot enter a network, and the network administrator determines the DHCP scope is exhausted. The administrator wants to avoid creating a new DHCP pool. Which of the following can the administrator perform to resolve the issue?

  1. Install load balancers
  2. Install more switches
  3. Decrease the number of VLANs
  4. Reduce the lease time

Question 10

An administrator is writing a script to periodically log the IPv6 and MAC addresses of all the devices on a network segment. Which of the following switch features will MOST likely be used to assist with this task?

  1. Spanning Tree Protocol
  2. Neighbor Discovery Protocol
  3. Link Aggregation Control Protocol
  4. Address Resolution Protocol