LSSMBB Practice Test

LSSMBB Practice Test practice questions, page 13 of 16, with answer review and explanations.

Question 61

The ________________ the discrimination, the __________________ the changes that can be detected by the measurement tool.

  1. Higher/higher
  2. Higher/smaller
  3. Smaller/smaller
  4. None of the above

Question 62

With Measurement Systems Analysis (MSA), we want to determine how much of the variation in our data is due to:

  1. Variation in our measurement system
  2. Manufacturing Equipment
  3. Part to part variation
  4. Lot to lot variation

Question 63

% R & R can be expressed as:

  1. % productivity divided by run rate
  2. % repeatability divided by production (rate)
  3. Sigma of the measurement system divided by total sigma
  4. Variance of the measurement system divided by total variance

Question 64

If you have a gauge study with a % R&R of 25% what should you do?

  1. Pull the tool from production.
  2. This is fine-go ahead.
  3. This is not acceptable for critical measurements, you should look into improvements in the measurement process.
  4. This is only an issue if you fail calibration.

Question 65

Three different operators perform MSA on 10 parts. They measure the same 10 parts twice. What would the Total # of readings be?

  1. 30
  2. 60
  3. 120
  4. 10