JN0-650: Enterprise Routing and Switching, Professional (JNCIP-ENT)

JN0-650: Enterprise Routing and Switching, Professional (JNCIP-ENT) practice questions, page 3 of 5, with answer review and explanations.

Question 11

Click the Exhibit button. Referring to the exhibit, you see that the 0.0.0.0/0 route is coming from AS 64512. What is the command to achieve this task?

  1. show route receive-protocol bgp
  2. show route protocol bgp source-gateway
  3. show route protocol bgp next-hop
  4. show route receive-protocol bgp hidden

Question 12

Click the Exhibit button. Your network receives the full Internet BGP routing table from two different ISPs. You want your local routers to use Provider A to forward all Internet traffic as long as Provider A is available. Referring to the exhibit, which two actions would satisfy this requirement? (Choose two.)

  1. Use a routing policy to set the local preference attribute value higher for the routes that are learned by R1.
  2. Use a routing policy to set the local preference attribute value higher for the routes that are learned by R2.
  3. Use a routing policy to set the local preference attribute value lower for the routes that are learned by R2.
  4. Use a routing policy to set the local preference attribute value lower for the routes that are learned by R1.

Question 13

Click the Exhibit button. Referring to the exhibit, what is required for the BGP peering to establish?

  1. Configure neighbor 172.16.1.1 multipath under the ext-peers hierarchy.
  2. Configure neighbor 10.10.20.1 multihop under the ext-peers hierarchy.
  3. Configure neighbor 10.10.10.1 multihop under the ext-peers hierarchy.
  4. Configure neighbor 172.16.1.1 multihop under the ext-peers hierarchy.

Question 14

Which two EVPN types advertise an ESI without advertising a MAC address? (Choose two.)

  1. Type 1
  2. Type 2
  3. Type 3
  4. Type 4

Question 15

Click the Exhibit button. Referring to the exhibit, which statement is correct?

  1. The device with the highest IP address is elected as the DR.
  2. The OSPF state will be stuck in the ExStart state.
  3. The OSPF state will be stuck in the 2Way state.
  4. The device with the lowest IP address is elected as the DR.