Hybrid Cloud Observability Network Monitoring practice questions, page 2 of 6, with answer review and explanations.
Question 6
Flow data is not generating from a device in the web console. Wireshark was used to confirm the flows are being sent from the device to the poller and not blocked by the firewall. Why is the data not showing in the web console?
device is not monitored by hybrid cloud observability (HCO) features
device is using IPv6 and HCO only supports IPv4
missing source address field in flow configurations
flow monitoring was not enabled as device type in web console settings
Question 7
Which two of the following tasks must be accomplished to monitor servers and connections in a load-balancing environment? (Choose two.)
add Cisco Nexus device in network device configuration manager
add Cisco Nexus device in network health / performance monitoring
enable CLI polling
enable F5 iControl polling
Question 8
What is a possible result of decreasing the top talking optimization value?
increased storage requirement
reduced database performance
reduced page load times
slower reporting speed
Question 9
Which two of the following troubleshooting steps can be performed when a node is “up” and the data cannot be found in SolarWinds’ platform web console? (Choose two.)
Add a remote site node and make sure the firewall rules are configured to allow SNMP traffic.
Ping the device from the polling engine the device is assigned to using the command line.
Verify hardware health sensors on the device provide both status and values.
Wait ten minutes after a device is added to the console. Refresh the screen.
Question 10
Which tool can be used to display the physical layout of interfaces on graphical stencils?