HPE7-A01 Practice Test

HPE7-A01 Practice Test practice questions, page 6 of 7, with answer review and explanations.

Question 26

What is enabled by LLDP-MED?

  1. Voice VLANs can be automatically configured for VoIP phones.
  2. GVRP VLAN information can be used to dynamically add VLANs to a trunk.
  3. iSCSI client devices can set the required MTU setting for the port.
  4. iSCSI client devices can request to have flow control enabled.

Question 27

Refer to the output from a CX6100 switch: What is the correct detail that can be observed from the output above?

  1. The dBm values for Tx are too far away from 0, and the link is down.
  2. the dBm values for Rx are within acceptable values, and the link is up.
  3. The dBm values for Rx are too low, indicating that the link is down.
  4. The dBm values for Tx are too high and affect Rx signals.

Question 28

What is true regarding 802.11k?

  1. It extends radio measurements to define mechanisms for wireless network management of stations.
  2. It reduces roaming delay by pre-authenticating clients with multiple target APs before a client roams to an AP.
  3. It provides mechanisms for APs and clients to dynamically measure the available radio resources.
  4. It considers several metrics before it determines if a client should be steered to the 5GHz band, including client RSSI.

Question 29

In a CX 8325, how do you configure the IP address 10.10.10.1 for the interface in default state for interface SVI 100 access and port 1/1/1?

  1. int vlan 100, ip address 10.10.10.1/24, int 1/1/1, switching, vlan access 100
  2. int vlan 100, ip address 10.10.10.1/24, int 1/1/1 vlan access 100
  3. int vlan 100, ip address 10.10.10.1/24, int 1/1/1, trunking, valn native 100
  4. int vlan, ip address 10.10.10.1/24, int 1/1/1, no routing, vlan access 100

Question 30

Your customer currently has two (2) 5406 modular switches with MSTP configured as their core switches. You are proposing a new solution. What would you explain regarding the AOS-CX VSX switch pair when the Spanning-tree needs to be set up?

  1. Enable vsx-peer stp-global in vsx mode to sync the configuration.
  2. Spanning-tree configuration is synced by default with VSX.
  3. Use vsx-sync in the MSTP region configuration to get synced.
  4. Enable vsx-sync stp-global in vsx mode to sync the configuration.