HPE7-A01 Practice Test

HPE7-A01 Practice Test practice questions, page 3 of 7, with answer review and explanations.

Question 11

You are deploying a bonded 40 MHz wide channel. What is the difference in the noise floor perceived by a client using this bonded channel as compared to an unbonded 20MHz wide channel?

  1. 6dB
  2. 8dB
  3. 3dB
  4. 4dB

Question 12

AppRF 2.0 allows you to:

  1. monitor applications and radio frequencies
  2. customize application signatures
  3. configure ACL and bandwidth control for applications
  4. classify web content based on reputation

Question 13

You need to have different routing-table requirements with CX 6300 VSF configuration. Assuming the correct layer-2 VLAN already exists, how would you create a new SVI for a separate routing table?

  1. Create a new VLAN, and attach the routing table to it.
  2. Create a new SVI and use attach vrf command.
  3. Create a new VLAN, and attach the VRF to it.
  4. Create a new routing table, and attach VLANs to it.

Question 14

You are setting up a customer’s 150 headless IoT devices that do not support 802.1X. What should you use?

  1. Multiple Pre-Shared Keys (MPSK) Local
  2. HPE Aruba Networking ClearPass profiling with WPA-PSK
  3. HPE Aruba Networking ClearPass profiling with MAC-AUTH
  4. Multiple Pre-Shared Keys (MPSK) with WPA3-AES

Question 15

How is Dynamic Multicast Optimization (DMO) implemented in an HPE Aruba Networking wireless network?

  1. DMO is configured individually for each VLAN in use in the network.
  2. The controller uses QoS to provide equal air time for multicast traffic.
  3. The controller converts multicast streams into unicast streams.
  4. The wireless AP converts multicast streams into unicast streams.