HPE6-A86 Practice Test practice questions, page 4 of 5, with answer review and explanations.
Question 16
A network is configured with two 2930F switches as the aggregation layer. Each 2930F switch has ten connections. The network has twenty 2530 access switches connected to both aggregation switches with 1Gb RJ45. Your task is to replace the aggregation switches with CX 6200 models. In this scenario, which configuration would provide redundancy using two ports on the access switches to the aggregation layer?
Create VSF on the CX 6200 and a lag for CX 6200 and 2530.
Create a single domain VSF for CX 6200 and 2530.
Create a lag on the 2530 to connect to both CX 6200 switches.
Create VSF on the CX 6200 and use stacking with the 2530.
Question 17
A security auditor asks whether you use any insecure management protocols to configure your CX-6200 switches from their factory default state. What can you tell them?
No, Telnet and HTTPS are enabled by default.
Yes, Telnet is enabled by default.
No, SSH and HTTPS are enabled by default.
Yes, HTTP is enabled by default.
Question 18
A Windows PC is not able to browse the Internet. Based on the output, what could be the problem?
A static route must be configured on the PC.
The port has been error-disabled by STP.
The wrong subnet mask has been configured.
There is no VLAN tag configured on the PC.
Question 19
The customer plans to roll out new CX 6000 and 6100 switches to replace the existing AOS-S switches. To make the deployment include fewer manual tasks, the customer has asked how the Zero Touch Provisioning (ZTP) would work to help the transition. Select the correct statement about ZTP.
The ZTP deployment is enabled by default on the management interface.
ZTP connects to HPE Aruba Networking Central and downloads the template configuration over SCP.
An SFTP server needs to be set up for the switch to download the initial configuration.
A DHCP server needs to be configured with the required options.
Question 20
The customer requires the highest speed available using a single port link between a CX 6200 and a CX 6300 over a distance of 1 meter (3 feet). Which is the correct validated connectivity option for a single port?