HPE6-A86 Practice Test

HPE6-A86 Practice Test practice questions, page 2 of 5, with answer review and explanations.

Question 6

A newly connected 500R series access point is not visible in HPE Aruba Networking Central. You have run the following commands to troubleshoot. Based on the output, what could be the problem?

  1. The AP does not support DHCP
  2. The DHCP server is not available
  3. The DHCP server must be in the same subnet as the AP
  4. The switch port should be configured as an access port

Question 7

Which commands can ensure the current configuration persists after a reboot? (Choose two.)

  1. commit confirm
  2. write memory
  3. save force
  4. copy startup-config running-config
  5. copy running-config startup-config

Question 8

Which statement is true when creating VLANs on an HPE Aruba Networking CX switch?

  1. A VLAN range can be created with a syntax of: vlan 100:110
  2. A VLAN range can be created with a syntax of: vlan 100-110
  3. A newly created VLAN needs to be enabled with a command: vlan 100 enable
  4. A newly created VLAN needs to be enabled with a command: vlan 100 no shutdown

Question 9

You have access to the CLI of an HPE Aruba Networking CX switch. How can you output the switch make, model, and serial number displayed on the session?

  1. Issue command: show support-information
  2. Issue command: diag dump basic
  3. Issue command: show configuration
  4. Issue command: show system

Question 10

Which firewall port needs to be opened between your Network Monitoring System and CX switches to collect monitoring data using SNMP?

  1. UDP 161
  2. UDP 1157
  3. TCP 162
  4. TCP 1156