HPE6-A71 Practice Test

HPE6-A71 Practice Test practice questions, page 5 of 5, with answer review and explanations.

Question 21

An administrator configures the MultiZone feature for a company network, where a mobility cluster is the primary zone and a standalone controller in the company's DMZ represents a secondary data zone. The administrator configures two AP Groups and respective VAPs for the zones on the Mobility Master (MM) in the primary zone. When the APs boot up and establish connections to both zones, the administrator notices that no data connections are established to the data zone. What must the administrator do to fix this problem?

  1. Configure the same AP Groups and VAPs on the standalone controller, and associate the MultiZone APs to both groups.
  2. Configure the same AP Group in the data zone as it is in the primary zone, and configure the VAPs in the data zone.
  3. Have the MultiZone APs initially boot from the standalone controller in the data zone.
  4. Create different AP Groups and VAPs on the Mobility Master and standalone controllers, and associate the MuttiZone APs to both groups.

Question 22

An administrator troubleshoots a roaming problem where a user loses connectivity to the network during the roaming process. To help troubleshoot this problem, which device or devices in a wireless network initiates the roaming process?

  1. the AP
  2. both the client and the controller
  3. the client
  4. the controller

Question 23

Which RAP WLAN operation mode should an administrator configure if the SSID should only be advertised if controller connectivity is lost?

  1. Standard
  2. Persistent
  3. Always
  4. Backup

Question 24

An administrator supports a cluster of four Aruba Mobility Controllers (MCs) with management addresses of 10.1.100.101, 10.1.100.102, 10.1.100.103, and 10.1.305.114. The administrator accesses an AP associated with this cluster, reboots it, and accesses apboot mode. The administrator executes the printenv command. Which AP parameter contains the IP addresses of the cluster members that the AP should use to connect to the cluster?

  1. master_ip
  2. cfg_lms
  3. servername
  4. nodelist

Question 25

Which ArubaOS CLI command can an administrator execute to determine if AP load balancing is enabled in a cluster?

  1. show switches
  2. show ap active
  3. show lc-cluster group-membership
  4. show aaa cluster essid