H12-211

H12-211 practice questions, page 14 of 17, with answer review and explanations.

Question 66

Which of the following statements are correct? (Choose two)

  1. A single collision domain exists between RTA and SWC.
  2. A single broadcast domain exists between SWA and SWB.
  3. A single collision domain exists between SWA and SWC.
  4. A single broadcast domain exists between SWA and SWC.

Question 67

On the interface serial 1/0/1 of RTA, the command "ip address unnumbered interface loopback 0" has been configured. Which following statements are correct? (Choose two).

  1. The IP address of interface serial 1/0/1 is 10.1.1.1/24
  2. The IP address of interface serial 1/0/1 is 10.1.1.1/32
  3. The route entry 10.1.1.0/24 exists in RTA's routing-table
  4. The route entry 10.1.1.0/24 does not exist in RTA's routing-table

Question 68

Refer to the graphic. The host has a problem establishing a telnet connection with the router attached to interface G0/0/0. Which of the following steps can be used to help the administrator identify the problem? (Choose two)

  1. Check whether the host has configured the gateway IP address.
  2. Check whether the switch has configured the gateway IP address.
  3. Use the ping tool to check connectivity between host and router.
  4. Check the telnet server configuration is right on the router.

Question 69

Which of the following methods are supported by VRP platform to configure the router? (Choose three)

  1. Through the Console port
  2. Through Telnet
  3. Through the AUX port
  4. Through FTP

Question 70

The administrator wishes to update the configuration file of an AR2200 router using a USB cable. How can this be achieved? (Choose all that apply.)

  1. The administrator should connect the USB cable between the terminal and the mini USB port of the AR2200 router.
  2. The administrator should connect the USB cable between the terminal and the USB port of the AR2200 router.
  3. The AR2200 router cannot support configuration updates through a USB cable.
  4. The administrator should install the mini USB drivers on the terminal after connecting the USB.