FCSS_SDW_AR-7.6 Practice Test

FCSS_SDW_AR-7.6 Practice Test practice questions, page 3 of 3, with answer review and explanations.

Question 11

Refer to the exhibits. SD-WAN template zones and rules configuration FortiManager error message - View install log in FortiManager You use FortiManager to configure SD-WAN on three branch devices. When you install the device settings, FortiManager prompts you with the error “Copy Failed” for the device branch1_fgt. When you click the log button, FortiManager displays the message shown in the exhibit. Based on the exhibits, which statement best describes the issue and how you can resolve it?

  1. Check the connection between branch1_fgt and FortiManager.
  2. Remove the installation target for the SD-WAN member port4. You cannot combine metadata variable and installation targets.
  3. Gateways for all members in a zone must be defined the same way. Specify the gateway of the SD-WAN member port1 without metadata variables.
  4. Check the metadata variable definitions, and review the per-device mapping configuration.

Question 12

Refer to the exhibits. SD-WAN zone HUB1 and SD-WAN member configuration SD-WAN zone HUB2 and SD-WAN member configuration Output of command diagnose sys sdwan member The exhibits show an SD-WAN zone HUB1 and SD-WAN member configuration from an SD-WAN template and the output of command diagnose sys sdwan member collected on a FortiGate device. Which statement best describes what the diagnose output shows?

  1. The diagnose output was collected on the device branch1_fgt.
  2. The diagnose output shows that HUB1-VPN1 and all HUBx-VPNy members are dead.
  3. The diagnose output was collected on the device branch2_fgt.
  4. The diagnose output does not correspond to a device configured with the SD-WAN template shown in the exhibit.