FCP_FSA_AD-5.0

FCP_FSA_AD-5.0 practice questions, page 2 of 2, with answer review and explanations.

Question 6

You must increase the scanning capacity of a FortiSandbox device by increasing the number of clones, but the FortiSandox local clone limit is already at maximum.Which two actions can you take to expand the scanning capacity of the unit? (Choose two.)

  1. Deploy remote WindowsCloudVM and MACOSX clones
  2. Reorganize the scan priority list
  3. Add custom VMs
  4. Add VM licenses to FortiSandbox

Question 7

Refer to the exhibit.Which command must you use to configure the worker node?

  1. hc-worker -a -s10.50.1.30 -p
  2. hc-worker -a -s10.25.1.50 -p
  3. hc-worker -a -s10.75.1.254 -p
  4. hc-worker -a -s10.25.1.30 -p

Question 8

To allow access to the FortiSandbox GUI the administrator must configure an IP address and a default gateway.Which two commands must the administrator use to accomplish this task? (Choose two.)

  1. set default-gw <IP Address>
  2. set api-port port1
  3. set admin-port port1
  4. set port1-ip <IP address>

Question 9

Refer to the exhibit.As a best practice, where must you rank the FortiClient inputs when configuring the job queue priority on FortiSandbox?

  1. Before FortiGate but after FortiMail inputs
  2. After all other input methods
  3. After On-Demand but before FortiGate inputs
  4. Before all other input methods

Question 10

To assign a file to a VM image, which two conditions must be true? (Choose two.)

  1. FortiSandbox must have the appropriate license entitlements.
  2. The VM image clone value must be a non-zero number.
  3. The file type must be configured to enter the job queue.
  4. The VM image must have the software required to open the file.