Question 1
What should be considered when using a direct air handler for a data centre?
- Cost of operation as power consumption on these units tend to be higher compared to traditional air conditioning technology.
- Temperature, humidity and contamination of the outdoor environment.
- Space available inside the computer rooms as the air handler space requirement for the inside the Computer room is quite large.
- The availability of three-phase power due to the high power requirements of these air handler units.
Question 2
Which of statements below is true?
- Single-mode cabling can use both LED and laser as a light source.
- Single-mode cabling is more expensive than multi-mode cabling.
- Multi-mode cabling can cross longer distances.
- Multi-mode cabling is more expensive than single-mode cabling.
Question 3
What level should the clean earth/ground resistance be for the data centre?
- < 1="" %="" of="" the="' line/phase="" to='" neutral="' voltage="' 1="" %="" of='"' the='" line/phase="" to="' neutral='">
- > 1 Ohm
- > 25 Ohm
- < 1=""ohm="' 1="">
Question 4
What type of heat does ICT equipment generate?
- Latent heat
- Sensible heat
- Both latent and sensible heat
- Radiant heat
Question 5
What is the main difference between an ATS and a STS?
- STS has a very fast switching time (e.g. less than 20 ms).
- STS has a slow switching time (e.g. more than 50 ms).
- STS is a make-before-break switch and an ATS is a break-before-make switch.
- STS is for high voltage and an ATS is for low voltage.