C2090-304

C2090-304 practice questions, page 2 of 3, with answer review and explanations.

Question 6

You are designing a reference match that will be run on a daily basis. Where should the reference data frequencies typically be generated?

  1. In a Server job in the same Job Sequence.
  2. In a shared container in the same job as the match.
  3. In a different job stream and part of the daily process.
  4. In a different job stream and not part of the daily process.

Question 7

Which statement is true about creating a Match Statistics report from a One-source match?

  1. You must use the Match Statistics stage.
  2. The One-source Match Statistics link target must be ODBC.
  3. The One-source Match Statistics link target must be a sequential file.
  4. The One-source Match Statistics link target can be any QualityStage supported target.

Question 8

Which two steps in the QualityStage Data Quality Methodology facilitates effective matching?

  1. Parsing
  2. Surviving
  3. Tokenization
  4. Data Mapping
  5. Standardization

Question 9

You re-ran a job to update the standardized data. This standardized data file is used in your test environment configuration on Match Designer. What action would you take to insure the most current standardized data file is used?

  1. No action is required.
  2. You need to open Test Environment and click [Update].
  3. You need to open Data Table Definition and click [Update].
  4. You need to click [Test All Passes] to apply changes in the standardized data.

Question 10

If a token had the value 13D and the "D" had to be isolated in a variable named Temp, what Pattern Action code would be used?

  1. COPY [1] Temp
  2. COPY [1](c) Temp
  3. COPY [1](-n) Temp
  4. COPY [1](-c) Temp