4A0-108

4A0-108 practice questions, page 6 of 10, with answer review and explanations.

Question 26

What is the destination address for MLDv2 report?

  1. FF02::1
  2. FF02::2
  3. FF02::16
  4. The specific multicast group address which the host is interested in

Question 27

In IPv6 multicast ASM mode, which of the following methods cannot be used to obtain the RP address?

  1. Static
  2. Router solicitation message
  3. Bootstrap message
  4. Embedded RP

Question 28

The network administrator of 2001:DB8:FEED::/64 wants to embed an RP for the network and the RP's address is 2001 :DB8:FEED::7. Which of the following multicast address ranges would suit this purpose? (The exhibit of Group-to-RP Mapping is just for your reference)

  1. FF7x:730:2001:DB8:FEED::/96(x is scope)
  2. FF7x:730:2001:DB8:FEED::/80(x is scope)
  3. FF7x:740:2001:DB8:FEED::/96(x is scope)
  4. FF7x:740:2001:DB8:FEED::/80(x is scope)

Question 29

Which of the following ranges is reserved for IPv6 SSM multicast address?

  1. FF1X::/16
  2. FF3X::/16
  3. FF3X::/96
  4. FF7X::/16

Question 30

Refer to the exhibit. According to the PIM configuration on SR-3, can the receiver in the diagram receive multicast traffic from the source for group FF70:340:2001::1000? Assume all the other configurations are correct.

  1. Yes. The configuration of PIM is correct and the receiver should get traffic from the source
  2. No. The configuration of PIM is no problem, but the scope of the group address used to send traffic is wrong
  3. No. As the "rpf6-table" command is missing
  4. No. As the embedded-rp group-range is wrong