4A0-108 practice questions, page 3 of 10, with answer review and explanations.
Question 11
How does a Candidate-RP send its information to the BSR?
Using PIM address 224.0.0.13
It is unicast to all the BSR candidates
It is flooded by all PIM routers
It is unicast to the elected BSR
Question 12
Refer to the exhibit. Which one of the following descriptions is correct, assuming that all the IGMP join, PIM join and multicast traffic are for the same multicast group?
IGMP is enabled on Router A and B's interfaces facing the switch. PIM is not enabled on Router A and B's interfaces facing the switch. IGMP snooping is enabled on the switch.
IGMP is enabled on Router A and B's interfaces facing the switch. PIM is not enabled on Router A and B's interfaces facing the switch. IGMP snooping is not enabled on the switch.
IGMP is enabled on Router A and B's interfaces facing the switch. PIM is enabled on Router A and B's interfaces facing the switch. IGMP snooping is enabled on the switch.
IGMP is enabled on Router A and B's interfaces facing the switch. PIM is enabled on Router A and B's interfaces facing the switch.
Question 13
When a BSR message with a higher priority is seen, will a new BSR election occur?
No, the new election only occurs when the elected BSR fails
Yes, after a bootstrap message wait interval
Yes, immediately
Depends on the local configuration of whether to allow the new election or not
Question 14
Which of the following is true regarding the IPv4 multicast address format?
The first 3 bits of the address set to '110'
A value between 223.0.0.0 and 239.255.255.255
The first 4 bits of the address set to '1111'
A subnet mask to indicate the network and host portion of the address
The first 4 bits of the address set to '1110'
Question 15
An end station receiving a broadcast packet will always process the data up to at least which layer of the OSI stack?