350-801 Practice Test

350-801 Practice Test practice questions, page 4 of 21, with answer review and explanations.

Question 16

On which Cisco Unified Communications Manager nodes can the TFTP service be enabled?

  1. any node
  2. any two nodes
  3. only nodes that have Cisco Unified CM service enabled
  4. any subscriber nodes

Question 17

Which issue causes slips on a PRI?

  1. incorrect clock source
  2. incorrect encapsulation
  3. incorrectly configured time zone
  4. change in the line code

Question 18

An administrator recently upgraded a Cisco Webex DX80 through its web interface but discovered the next morning that the unit has received to its previous version. What must the administrator do to prevent this from happening again?

  1. Assign a phone security profile with secure SIP.
  2. Set the prepare cluster for rollback to pre-8.0 enterprise parameter to true.
  3. Confirm the phone load name in the phone configuration.
  4. Assign a universal device template to the phone.

Question 19

An engineer is notified that the Cisco TelePresence MX800 that is registered in Cisco Unified Communications Manager shows an empty panel, and the Touch 10 shows a corresponding icon with no action when pressed. Where does the engineer go to remove the inactive custom panel?

  1. The Software Upgrades page in CUCM OS Administration
  2. The In-Room Control Editor on the webpage of the MX800
  3. The phone configuration page in CUCM Administration
  4. The SIP Trunk Security Profile page in CUCM Administration

Question 20

A presence redundancy group is deployed, and an engineer initiates a manual fallback. Which statement about Cisco Server Recovery Manager is true?

  1. disconnects all users that had been failed over, and the users must log in again
  2. disconnects all users that had been failed over
  3. restarts critical services on the secondary node
  4. restarts the Cisco Presence Engine