350-601 Practice Test

350-601 Practice Test practice questions, page 8 of 21, with answer review and explanations.

Question 36

An engineer needs to create a new user in the local user database on Cisco UCS Fabric Interconnect. The user needs permissions to change the following configuration inside UCS Manager version 3.1: ✑ vNIC and vHBA profiles ✑ Fan speed and power redundancy profile of UCS Manager Which two roles must be assigned to a user to achieve this goal? (Choose two.)

  1. facility-manager
  2. server-equipment
  3. operations
  4. server-profile
  5. server-compute

Question 37

Refer to the exhibit. Cisco Fabric Services is enabled in the network. Which type of IP address is used by the Cisco Fabric Services protocol?

  1. IPv4 multicast address
  2. IPv4 unicast address
  3. IPv4 gateway address
  4. IPv4 anycast address

Question 38

Refer to the exhibit. A network engineer plans to upgrade the current software images of a Cisco Nexus switch. What is the impact of starting the EPLD upgrade?

  1. The switch reboots one time for the new EPLD versions to take effect.
  2. The switch reboots multiple times for the new EPLD versions to take effect.
  3. The switch skips the EPLD upgrade for each EPLD device of the switch.
  4. The switch skips the EPLD upgrade for MIFPGA and proceeds with the other EPLD devices.

Question 39

Which behavior defines streaming telemetry as a push model in Cisco devices?

  1. Events and network changes generate telemetry data
  2. Monitoring clients are pulling data from the network to see real-time statistics
  3. JSON encoded telemetry data is transported using the gRPC protocol
  4. The network devices send data in JSON or GPB format to configure endpoints

Question 40

After a Cisco Nexus 7000 Series Switch chassis replacement, the administrator discovers that all vPC-enabled LACP port channels are reinitialized. The administrator wants to prevent this issue the next time the chassis is replaced. Which two actions must be taken to meet this requirement before the isolated device is reloaded? (Choose two.)

  1. Change the vPC system-priority of the replacement chassis to a higher value than the peer
  2. Set the vPC MAC address to a higher value than the peer
  3. Configure auto-recovery to the disable state on both peers
  4. Set the vPC MAC address to a lower value than the peer
  5. Change the vPC system-priority of the replacement chassis to a lower value than the peer