350-601 Practice Test

350-601 Practice Test practice questions, page 17 of 21, with answer review and explanations.

Question 81

An engineer must implement a disaster recovery policy for the Cisco UCS infrastructure. The solution must meet these criteria: ✑ The Recovery Point Objective must be 48 hours. ✑ The backup must use encrypted transmission. The Recovery Time Objective must be 4 hours. Which configuration set must be used in the scheduled backup to meet these requirements?

  1. Protocol: FTP Schedule: Bi-Weekly
  2. Protocol: SFTP Schedule: Weekly
  3. Protocol: TFTP Schedule: Bi-Weekly
  4. Protocol: SCP Schedule: Daily

Question 82

Refer to the exhibit. What happens to the broadcast traffic when it reaches aggregation switches?

  1. Agg-2 switch receives broadcast packets and stops forwarding to the peer link on Agg-1 switch.
  2. Agg-1 switch prevents broadcast packets received on the vPC peer link from exiting the switch on ports Eth2/4 and Eth2/5.
  3. Agg-1 and Agg-2 switches receive broadcast packets and does not forward them to the peer link or the port channel.
  4. Only Agg-1 switch receives broadcast packets and does not forward to the peer link on Agg-2 switch.

Question 83

Which feature is supported with an In-Service Software Upgrade on a Cisco Nexus 9000 Series Switch?

  1. nondisruptive upgrades via nonstop forwarding
  2. configuration changes during an upgrade
  3. upgrades to individual modules and line cards
  4. zero downtime downgrades via dual supervisor modules

Question 84

An engineer must configure a monitoring solution for a Cisco Nexus 9000 Series Switch based data center. The solution must provide real-time insight into the network health with subscription-based monitoring. The monitoring must be initiated from the client side, and the data must be sent via encryption. Which configuration steps complete the configuration?

  1. Configure Grafana on the Nexus switch. Specify the logging certificate. Enable syslog level 7 export to Grafana.
  2. Set the telemetry feature on the Nexus switch. Specify a certificate for telemetry transport. Configure a sensor group and destination.
  3. Activate SNMPv3 on the Nexus switch. Set the globalEnforcePriv parameter. Configure an SNMP agent to poll information.
  4. Enable GRPC on the Nexus switch. Generate a certificate. Configure gNMI inputs in Telegraf and output to InfluxDB.

Question 85

Refer to the exhibit. Software downgrade is required on a Cisco Nexus 7000 Series Switch. What is displayed when this command is executed?

  1. features that are enabled automatically after the downgrade
  2. impact of a software upgrade in ISSU and chassis reload
  3. features and commands that are removed automatically from the configuration
  4. compatibility of software in the system bootflash file