350-501 Practice Test

350-501 Practice Test practice questions, page 5 of 21, with answer review and explanations.

Question 21

Refer to the exhibit. An engineer is preparing to implement data plane security configuration. Which statement about this configuration is true?

  1. Router 1 and Router 2 advertise the route to 192.0.2.0 to all BGP peers.
  2. All traffic to 192.168.1.0/24 is dropped.
  3. All traffic is dropped.
  4. Router 1 drops all traffic with a local-preference set to 150.

Question 22

Which MPLS design attribute can you use to provide Internet access to a major customer through a separate dedicated VPN?

  1. The Internet gateway router is connected as a PE router to the MPLS backbone.
  2. The CE router supports VRF-Lite and the full BGP routing table.
  3. The Internet gateway inserts the full Internet BGP routing table into the Internet access VPN.
  4. The customer that needs the Internet access service is assigned to the same RTs as the Internet gateway.

Question 23

Which configuration enables BGP FlowSpec client function and installation of policies on all local interfaces?

  1. flowspec address-family ipv4 local-install interface-all
  2. flowspec address-family ipv4 install interface-all local
  3. flowspec address-family ipv4 install interface-all
  4. flowspec address-family ipv4 local-install all-interface

Question 24

Refer to the exhibit. A network engineer is configuring customer edge routers to finalize a L2VPN over MPLS deployment. Assume that the AToM L2VPN service that connects the two CEs is configured correctly on the service provider network. Which action causes the solution to fail?

  1. OSPF does not work with L2VPN services.
  2. The routing protocol network types are not compatible.
  3. A loopback with a /32 IP address has not been used.
  4. The xconnect statement has not been defined.

Question 25

An engineer working for telecommunication company needs to secure the LAN network using a prefix list. Which best practice should the engineer follow when he implements a prefix list?

  1. An engineer must identify the prefix list with a number only.
  2. The final entry in a prefix list must be /32.
  3. An engineer must include only the prefixes for which he needs to log activity.
  4. An engineer must use nonsequential sequence numbers in the prefix list so that he can insert additional entries later.