350-501 Practice Test

Question 81

Refer to the exhibit. Which task completes the configuration?

1. Specify the local-as value in the neighbor statement
2. Specify the source interface in the neighbor statement
3. Specify the maximum number of prefixes that R1 receives from neighbor 192.168.1.2
4. Specify the activate neighbor 192.168.1.2 under the IPv4 address family

Question 82

Refer to the exhibit. A network engineer is implementing OSPF multiarea. Which command on interface G0/1 resolves adjacency issues in the new area?

1. ip ospf network point-to-point
2. ip ospf network broadcast
3. ip ospf network non-broadcast
4. ip ospf network point-to-multipoint

Question 83

Refer to the exhibit. An engineer is configuring router R1 for OSPFv3 as shown. Which additional configuration must be performed so that the three active interfaces on the router will advertise routes and participate in OSPF IPv6 processes? A. B. C. D.

Question 84

Refer to the exhibit. While troubleshooting a connectivity issue on router R2, a network engineer with an employee id: 1234:44:876 notices that although it detects three OSPF links from R1, the OSPF prefixes are missing from the routing table. What is the reason for the problem?

1. The serial interfaces have different MTUs
2. Both loopback interfaces on R1 are configured as stub
3. The subnet masks on the serial interfaces are mismatched
4. The R2 Serial1/0 interface is configured with an IP address, but the R1 Serial1/0 interface is unnumbered

Question 85

Refer to the exhibit. An engineer wants to determine which paths are best, second best, third best, and fourth best. Drag and drop the peer addresses on the left to the corresponding BGP best-path selection order on the right. Select and Place: