350-501 Practice Test

350-501 Practice Test practice questions, page 15 of 21, with answer review and explanations.

Question 71

A network engineer is deploying VRF on ASBR router R1. The interface must have connectivity over an MPLS VPN Inter-AS Option AB network. Which configuration must the engineer apply on the router to accomplish this task? A. B. C. D.

Question 72

Refer to the exhibit. ASN 64501 currently reaches the networks under the 10.0.0.0/8 prefix via the North_B router, which is a slow backup link. The administrator of ASN 64502 wants traffic from ASN 64501 to 10.0.0.0/8 to travel via the primary link, North_A. Which change to the network configuration accomplishes this task?

  1. Set a higher local preference between North_A and South-A
  2. Set a lower MED between North_B and South_B
  3. Advertise the 10.0.0.0/8 prefix through North_B and specific subnets through North_A
  4. Set a lower Weight value for incoming traffic on North_A

Question 73

Refer to the exhibit. Router 1 is missing the route for the router 2 loopback 0. What should the engineer change to fix the problem?

  1. Router 1 to be an ABR
  2. the wildcard mask network statement in OSPF of Router 2
  3. the hello timers on Router 1 and Router 2 to be different
  4. the area numbers on Router 1 and Router 2 to be similar

Question 74

Refer to the exhibit. Which two topology changes happen to the IS-IS routers? (Choose two.)

  1. R1 and R4 are Level 2 neighbors
  2. All four routers are operating as Level 1-2 routers
  3. All four routers are operating as Level 2 routers only
  4. R1 and R2 are Level 2 neighbors
  5. All four routers are operating as Level 1 routers only

Question 75

An engineer is trying to implement BGP in a multihomed architecture. What must the engineer configure to influence inbound path selection?

  1. A route map with AS-PATH attribute to control the inbound traffic
  2. An offset list to set the metric for routes received from neighboring autonomous systems
  3. An access list to identify traffic and enable it on both of the provider-facing interfaces
  4. A route map with WEIGHT attribute to control the inbound traffic