350-501 Practice Test

350-501 Practice Test practice questions, page 11 of 21, with answer review and explanations.

Question 51

Refer to the exhibit. Which configuration prevents the OSPF neighbor from establishing?

  1. default-metric
  2. duplex
  3. network statement
  4. mtu

Question 52

Refer to the exhibit. R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed. When the debug ip ospf hello command is issued on R1, these log messages are seen: Which command can be configured on routers R1 and R2 on f0/0 interfaces to form OSPF adjacency?

  1. ip ospf network point-to-multipoint non-broadcast
  2. ip ospf network non-broadcast
  3. ip ospf network broadcast
  4. ip ospf network point-to-point

Question 53

Which two tasks must you perform when you implement LDP NSF on your network? (Choose two.)

  1. Enable NSF for BGP.
  2. Implement direct connections for LDP peers.
  3. Enable NSF for EIGRP.
  4. Disable Cisco Express Forwarding.
  5. Enable NSF for the link-state routing protocol that is in use on the network.

Question 54

Refer to the exhibit. On R1, which output does the show isis neighbors command generate? A. B. C. D.

Question 55

Refer to the exhibit. Assume all other configurations are correct and the network is otherwise operating normally. Which conclusion can you draw about the neighbor relationship between routers R1 and R2?

  1. The neighbor relationship is up.
  2. The neighbor relationship will be up only if the two devices have activated the correct neighbor relationships under the IPv4 address family.
  3. The neighbor is down because the local-as value for R2 is missing in the R1 neighbor statement.
  4. The neighbor relationship is down because R1 believes R2 is in AS 65012.