350-401 Practice Test

350-401 Practice Test practice questions, page 9 of 43, with answer review and explanations.

Question 41

While configuring an IOS router for HSRP with a virtual IP of 10.1.1.1, an engineer sees this log message. Jan 1 12:12:12.111 : %HSRP-4-DIFFVIP1: GigabitEthernet0/0 Grp 1 active routers virtual IP address 10.1.1.1 is different to the locally configured address 10.1.1.25 Which configuration change must the engineer make?

  1. Change the HSRP group configuration on the local router to 1.
  2. Change the HSRP virtual address on the local router to 10.1.1.1.
  3. Change the HSRP virtual address on the remote router to 10.1.1.1.
  4. Change the HSRP group configuration on the remote router to 1.

Question 42

A network administrator has designed a network with two multilayer switches on the distribution layer, which act as default gateways for the end hosts. Which two technologies allow every end host in a VLAN to use both gateways? (Choose two.)

  1. VRRP
  2. GLBP
  3. VSS
  4. MHSRP
  5. HSRP

Question 43

Refer to the exhibit. On which interfaces should VRRP commands be applied to provide first hop redundancy to PC-01 and PC-02?

  1. G0/0 and G0/1 on Core
  2. G0/0 on Edge-01 and G0/0 on Edge-02
  3. G0/1 on Edge-01 and G0/1 on Edge-02
  4. G0/0 and G0/1 on ASW-01

Question 44

Under which network conditions is an outbound QoS policy that is applied on a router WAN interface most beneficial?

  1. under traffic classification and marking conditions
  2. under interface saturation conditions
  3. under all network conditions
  4. under network convergence conditions

Question 45

An engineer must configure HSRP group 300 on a Cisco IOS router. When the router is functional, it must be the active HSRP router. The peer router has been configured using the default priority value. Which command set is required?

  1. standby version 2 standby 300 priority 110 standby 300 preempt
  2. standby 300 priority 110 standby 300 timers 1 110
  3. standby version 2 standby 300 priority 90 standby 300 preempt
  4. standby 300 priority 90 standby 300 preempt