350-401 Practice Test

350-401 Practice Test practice questions, page 40 of 43, with answer review and explanations.

Question 196

A client device fails to see the enterprise SSID, but other client devices are connected to it. What is the cause of this issue?

  1. The client has incorrect credentials stored for the configured broadcast SSID.
  2. The hidden SSID was not manually configured on the client.
  3. The broadcast SSID was not manually configured on the client.
  4. The client has incorrect credentials stored for the configured hidden SSID.

Question 197

Which two descriptions of FlexConnect mode for Cisco APs are true? (Choose two.)

  1. APs that operate in FlexConnect mode cannot detect rogue APs.
  2. When connected to the controller, FlexConnect APs can tunnel traffic back to the controller.
  3. FlexConnect mode is used when the APs are set up in a mesh environment and used to bridge between each other.
  4. FlexConnect mode is a feature that is designed to allow specified CAPWAP-enabled APs to exclude themselves from managing data traffic between clients and infrastructure.
  5. FlexConnect mode is a wireless solution for branch office and remote office deployments.

Question 198

Refer to the exhibit. How was spanning-tree configured on this interface?

  1. By entering the command spanning-tree portfast trunk in the interface configuration mode.
  2. By entering the command spanning-tree mst1 vlan 10,20,30,40 in the global configuration mode.
  3. By entering the command spanning-tree portfast in the interface configuration mode.
  4. By entering the command spanning-tree vlan 10,20,30,40 root primary in the interface configuration mode.

Question 199

Refer to the exhibit. Rapid PVST+ is enabled on all switches. Which command set must be configured on Switch1 to achieve the following results on port fa0/1? ✑ When a device is connected, the port transitions immediately to a forwarding state. ✑ The interface should not send or receive BPDUs. ✑ If a BPDU is received, it continues operating normally.

  1. Switch1(config)# spanning-tree portfast bpdufilter default Switch1(config)# interface f0/1 Switch1(config-if)# spanning-tree portfast
  2. Switch1(config)# spanning-tree portfast bpduguard default Switch 1 (config)# interface f0/1 Switch1 (config-if)# spanning-tree portfast
  3. Switch1(config)# interface f0/1 Switch1(config-if)# spanning-tree portfast
  4. Switch1(config)# interface f0/1 Switch1(config-if)# spanning-tree portfast Switch1 (config-if)# spanning-tree bpduguard enable

Question 200

Refer to the exhibit. Which configuration change will force BR2 to reach 209.165.201.0/27 via BR1?

  1. Set the MED to 1 on PE2 toward BR2 outbound.
  2. Set the origin to igp on BR2 toward PE2 inbound.
  3. Set the weight attribute to 65,535 on BR1 toward PE1.
  4. Set the local preference to 150 on PE1 toward BR1 outbound.