350-401: Implementing Cisco Enterprise Network Core Technologies (ENCOR)

350-401: Implementing Cisco Enterprise Network Core Technologies (ENCOR) practice questions, page 34 of 43, with answer review and explanations.

Question 166

Refer to the exhibit. Which command allows hosts that are connected to FastEthernet0/2 to access the Internet?

  1. ip nat inside source list 10 interface FastEthernet0/2 overload
  2. ip nat inside source list 10 interface FastEthernet0/1 overload
  3. ip nat outside source static 209.165.200.225 10.10.10.0 overload
  4. ip nat outside source list 10 interface FastEthernet0/2 overload

Question 167

Refer to the exhibit. What are two effects of this configuration? (Choose two.)

  1. If R1 goes down, R2 becomes active but reverts to standby when R1 comes back online.
  2. If R2 goes down, R1 becomes active but reverts to standby when R2 comes back online.
  3. R1 becomes the active router.
  4. R1 becomes the standby router.
  5. If R1 goes down, R2 becomes active and remains the active device when R1 comes back online.

Question 168

Refer to the exhibit. An engineer must ensure that all traffic entering AS 200 from AS 100 chooses Link 2 as an entry point. Assume that all BGP neighbor relationships have been formed and that the attributes have not been changed on any of the routers. Which configuration accomplishes this task?

  1. R3(config)#route-map PREPEND permit 10 R3(config-route-map)#set as-path prepend 200 200 200 R3(config)#router bgp 200 R3#(config-router)#neighbor 10.1.1.1 route-map PREPEND out
  2. R4(config)#route-map PREPEND permit 10 R4(config-route-map)#set as-path prepend 100 100 100 R4(config)#router bgp 200 R4(config-router)#neighbor 10.2.2.2 route-map PREPEND in
  3. R4(config)#route-map PREPEND permit 10 R4(config-route-map)#set as-path prepend 200 200 200 R4(config)#router bgp 200 R4(config-router)#neighbor 10.2.2.2 route-map PREPEND out
  4. R3(config)#route-map PREPEND permit 10 R3(config-route-map)#set as-path prepend 100 100 100 R3(config)#router bgp 200 R3(config-router)#neighbor 10.1.1.1 route-map PREPEND in

Question 169

Which DHCP option provides the CAPWAP APs with the address of the wireless controller(s)?

  1. 43
  2. 66
  3. 69
  4. 150

Question 170

Refer to the exhibit. Which two commands ensure that DSW1 becomes root bridge for VLAN 10? (Choose two.)

  1. DSW1(config)#spanning-tree vlan 10 priority 4096
  2. DSW1(config)#spanning-tree vlan 10 priority root
  3. DSW2(config)#spanning-tree vlan 10 priority 61440
  4. DSW1(config)#spanning-tree vlan 10 port-priority 0
  5. DSW2(config)#spanning-tree vlan 20 priority 0