350-401 Practice Test

350-401 Practice Test practice questions, page 32 of 43, with answer review and explanations.

Question 156

Refer to the exhibit. Which command must be applied to R2 for an OSPF neighborship to form?

  1. network 20.1.1.2 255.255.0.0 area 0
  2. network 20.1.1.2 0.0.0.0 area 0
  3. network 20.1.1.2 255.255.255.255 area 0
  4. network 20.1.1.2 0.0.255.255 area 0

Question 157

Refer to the exhibit. Which router is the designated router on the segment 192.168.0.0/24?

  1. This segment has no designated router because it is a p2p network type.
  2. Router Chicago because it has a lower router ID.
  3. Router NewYork because it has a higher router ID.
  4. This segment has no designated router because it is a nonbroadcast network type.

Question 158

Refer to the exhibit. Which two commands are needed to allow for full reachability between AS 1000 and AS 2000? (Choose two.)

  1. R2#no network 10.0.0.0 255.255.255.0
  2. R2#network 209.165.201.0 mask 255.255.192.0
  3. R2#network 192.168.0.0 mask 255.255.0.0
  4. R1#no network 10.0.0.0 255.255.255.0
  5. R1#network 192.168.0.0 mask 255.255.0.0

Question 159

Refer to the exhibit. An engineer attempts to configure a router on a stick to route packets between Clients, Servers, and Printers; however, initial tests show that this configuration is not working. Which command set resolves this issue?

  1. interface Vlan10 no ip vrf forwarding Clients ! interface Vlan20 no ip vrf forwarding Servers ! interface Vlan30 no ip vrf forwarding Printers
  2. router eigrp 1 network 10.0.0.0 255.255.255.0 network 172.16.0.0 255.255.255.0 network 192.168.1.0 255.255.255.0
  3. interface Vlan10 no ip vrf forwarding Clients ip address 192.168.1.1. 255.255.255.0 ! interface Vlan20 no ip vrf forwarding Servers ip address 172.16.1.1 255.255.255.0 ! interface Vlan30 no ip vrf forwarding Printers ip address 10.1.1.1 255.255.255.0
  4. router eigrp 1 network 10.0.0.0 255.0.0.0 network 172.16.0.0 255.255.0.0 network 192.168.1.0 255.255.0.0

Question 160

How does SSO work with HSRP to minimize network disruptions?

  1. It enables HSRP to elect another switch in the group as the active HSRP switch.
  2. It ensures fast failover in the case of link failure.
  3. It enables data forwarding along known routes following a switchover, while the routing protocol reconverges.
  4. It enables HSRP to failover to the standby RP on the same device.