350-401 Practice Test

350-401 Practice Test practice questions, page 30 of 43, with answer review and explanations.

Question 146

Company policy restricts VLAN 10 to be allowed only on SW1 and SW2. All other VLANs can be on all three switches. An administrator has noticed that VLAN 10 has propagated to SW3. Which configuration corrects the issue?

  1. SW1(config)#int gi1/1 SW1(config)#switchport trunk allowed vlan 1-9,11-4094
  2. SW2(config)#int gi1/2 SW2(config)#switchport trunk allowed vlan 10
  3. SW2(config)#int gi1/2 SW2(config)#switchport trunk allowed vlan 1-9,11-4094
  4. SW1(config)#int gi1/1 SW1(config)#switchport trunk allowed vlan 10

Question 147

Which First Hop Redundancy Protocol should be used to meet a design requirement for more efficient default gateway bandwidth usage across multiple devices?

  1. GLBP
  2. LACP
  3. HSRP
  4. VRRP

Question 148

A client device roams between access points located on different floors in an atrium. The access points are joined to the same controller and configured in local mode. The access points are in different AP groups and have different IP addresses, but the client VLAN in the groups is the same. Which type of roam occurs?

  1. inter-controller
  2. inter-subnet
  3. intra-VLAN
  4. intra-controller

Question 149

Which DHCP option helps lightweight APs find the IP address of a wireless LAN controller?

  1. Option 43
  2. Option 60
  3. Option 67
  4. Option 150

Question 150

Refer to the exhibit. A network engineer is configuring OSPF between router R1 and router R2. The engineer must ensure that a DR/BDR election does not occur on the Gigabit Ethernet interfaces in area 0. Which configuration set accomplishes this goal?

  1. R1(config-if)interface Gi0/0 R1(config-if)ip ospf network point-to-point R2(config-if)interface Gi0/0 R2(config-if)ip ospf network point-to-point
  2. R1(config-if)interface Gi0/0 R1(config-if)ip ospf network broadcast R2(config-if)interface Gi0/0 R2(config-if)ip ospf network broadcast
  3. R1(config-if)interface Gi0/0 R1(config-if)ip ospf database-filter all out R2(config-if)interface Gi0/0 R2(config-if)ip ospf database-filter all out
  4. R1(config-if)interface Gi0/0 R1(config-if)ip ospf priority 1 R2(config-if)interface Gi0/0 R2(config-if)ip ospf priority 1