350-401 Practice Test

350-401 Practice Test practice questions, page 24 of 43, with answer review and explanations.

Question 116

Which statement about multicast RPs is true?

  1. RPs are required only when using protocol independent multicast dense mode.
  2. RPs are required for protocol independent multicast sparse mode and dense mode.
  3. By default, the RP is needed periodically to maintain sessions with sources and receivers.
  4. By default, the RP is needed only to start new sessions with sources and receivers.

Question 117

To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller. Which EtherChannel mode must be configured on the switch to allow the WLC to connect?

  1. Active
  2. Passive
  3. On
  4. Auto

Question 118

Based on this interface configuration, what is the expected state of OSPF adjacency?

  1. 2WAY/DROTHER on both routers
  2. not established
  3. FULL on both routers
  4. FULL/BDR on R1 and FULL/BDR on R2

Question 119

Refer to the exhibit. Link1 is a copper connection and Link2 is a fiber connection. The fiber port must be the primary port for all forwarding. The output of the show spanning-tree command on SW2 shows that the fiber port is blocked by spanning tree. An engineer enters the spanning-tree port-priority 32 command on G0/1 on SW2, but the port remains blocked. Which command should be entered on the ports that are connected to Link2 to resolve the issue?

  1. Enter spanning-tree port-priority 4 on SW2.
  2. Enter spanning-tree port-priority 32 on SW1.
  3. Enter spanning-tree port-priority 224 on SW1.
  4. Enter spanning-tree port-priority 64 on SW2.

Question 120

Which behavior can be expected when the HSRP version is changed from 1 to 2?

  1. No changes occur because the standby router is upgraded before the active router.
  2. No changes occur because version 1 and 2 use the same virtual MAC OUI.
  3. Each HSRP group reinitializes because the virtual MAC address has changed.
  4. Each HSRP group reinitializes because the multicast address has changed.