350-401 Practice Test

350-401 Practice Test practice questions, page 12 of 43, with answer review and explanations.

Question 56

Refer to the exhibit. An engineer is installing a new pair of routers in a redundant configuration. When checking on the standby status of each router, the engineer notices that the routers are not functioning as expected. Which action will resolve the configuration error?

  1. configure matching hold and delay timers
  2. configure matching key-strings
  3. configure matching priority values
  4. configure unique virtual IP addresses

Question 57

Refer to the exhibit. Router1 is currently operating as the HSRP primary with a priority of 110. Router1 fails and Router2 takes over the forwarding role. Which command on Router1 causes it to take over the forwarding role when it returns to service?

  1. standby 2 priority
  2. standby 2 preempt
  3. standby 2 track
  4. standby 2 timers

Question 58

An engineer has deployed a single Cisco 5520 WLC with a management IP address of 172 16.50.5/24. The engineer must register 50 new Cisco AIR-CAP2802I- E-K9 access points to the WLC using DHCP option 43. The access points are connected to a switch in VLAN 100 that uses the 172.16.100.0/24 subnet. The engineer has configured the DHCP scope on the switch as follows: Network 172.16.100.0 255.255.255.0 Default Router 172.16.100.1 - Option 43 ASCII 172.16.50.5 - The access points are failing to join the wireless LAN controller. Which action resolves the issue?

  1. configure option 43 Hex F104.AC10.3205
  2. configure option 43 Hex F104.CA10.3205
  3. configure dns-server 172.16.50.5
  4. configure dns-server 172. 16.100.1

Question 59

What is the role of vSmart in a Cisco SD-WAN environment?

  1. to establish secure control plane connections
  2. to monitor, configure, and maintain SD-WAN devices
  3. to provide secure data plane connectivity over WAN links
  4. to perform initial authentication of devices

Question 60

Which action is performed by Link Management Protocol in a Cisco StackWise Virtual domain?

  1. It determines which switch becomes active or standby.
  2. It determines if the hardware is compatible to form the StackWise Virtual domain.
  3. It rejects any unidirectional link traffic forwarding.
  4. It discovers the StackWise domain and brings up SVL interfaces.